A P90 humbucker!
Seymour Duncan's STK-P1 Stacked P90 delivers a noiseless, vintage-style, P90 soapbar tone for any guitar with a P90-sized pickup route. You get the growl and sparkle, but none of the pesky hum that traditional single coils have.
The neck model sounds nice and full, with just the right amount of low-end growl, while the bridge model sounds nice and midrangy, with all the classic grit that you’d expect out of a great bridge-position P90.
The 4-conductor lead wire gives you the option to split the coils if you want, or to switch into series mode for a more compressed sound. At .95" in height, these noiseless P90 pickups are a little taller than a typical P90, so you may want to make sure your guitars pickup slots are deep enough before trying to install them.
Hand built in Santa Barbara, CA, the STK-P1 Stacked P90 uses dual Alnico 5 magnets, 4-conductor lead wire, and is vacuum wax potted for squeal-free operation. Noiseless P90 Soapbar pickups provide the tone of a traditional P90 single coil without any of the hum.
The 4-conductor lead wire gives you the option to split the coils if you want, or to switch into series mode for a more compressed sound. At .95" in height, these noiseless P90 pickups are a little taller than a typical P90, so you may want to make sure your guitars pickup slots are deep enough before trying to install them.
Hand built in Santa Barbara, CA, the STK-P1 Stacked P90 uses dual Alnico 5 magnets, 4-conductor lead wire, and is vacuum wax potted for squeal-free operation. Noiseless P90 Soapbar pickups provide the tone of a traditional P90 single coil without any of the hum.